Electrolux Washer Error E60 — What It Means & How to Fix It

What Does This Error Mean?

E60 on an Electrolux washer means the heating element circuit has a fault. The machine started a hot wash cycle but cannot heat the water to the required temperature. This is usually a failed heating element, a tripped thermal fuse, or a faulty NTC temperature sensor.

Affected Models

Electrolux EFLS627UTT
Electrolux EFLS527UTT
Electrolux ELFW7637AT
Electrolux ELFW7537AT
Electrolux EFL-Series Front Load

Common Causes

The heating element has burned out and no longer heats the water
The thermal fuse on the heating element has blown to protect against overheating
The NTC temperature sensor is faulty and is reporting incorrect water temperature
A loose or broken wire connection to the heating element or sensor
The main control board has failed to energize the heating element circuit

How to Fix It

Unplug the washer for 3 minutes then plug it back in. Set a cool wash cycle (30°C or cold) and run it. Note whether the error appears on all temperatures or only hot washes.

If E60 only appears on hot wash cycles, the heating element is likely faulty. If it appears on cold cycles too, the issue may be in the control board or wiring.
Check whether your laundry room fuse box has tripped a circuit. A failed heating element can sometimes draw enough current to trip a breaker.

A tripped breaker does not fix the problem — the heating element still needs to be replaced — but restoring power is the first step.
To confirm the heating element has failed, unplug the machine and access the element (usually through the rear panel or drum access panel). Test the element's resistance with a multimeter.

A working heating element will show a resistance reading. An open circuit (infinite resistance) means the element has burned out.
While the heating element is accessible, check the thermal fuse attached to it. Test the fuse with a multimeter for continuity.

If the thermal fuse has blown (no continuity), replace both the fuse and the heating element — the fuse blows because the element overheated.
Check the NTC temperature sensor — a small probe clipped to the heating element or drum. Test it for resistance: it should read around 10,000 ohms at room temperature.

A faulty NTC sensor tells the control board the water is already hot, so the board never turns on the heater. This causes E60 without the heating element actually being broken.
If E60 persists after replacing the heating element and thermal fuse, the main control board may be failing to switch power to the element. A technician can verify this.

Board-related E60 is less common but does occur on older machines.

When to Call a Professional

If a reset and wire check do not resolve E60, the heating element likely needs to be replaced. This involves draining the machine and accessing the element from the back or bottom. A technician can replace the heating element for $120 to $200 including parts and labor.

Frequently Asked Questions

Will E60 affect cold wash cycles?

Cold wash cycles do not use the heating element, so they should run normally. However, the machine may still stop and show E60 if it detects a circuit fault at startup. Test a cold cycle first to see if it completes.

Is E60 dangerous — could the washer overheat?

E60 means the heater is not working — the risk is under-heating, not overheating. The machine cannot boil clothes or cause a fire from E60 alone. The thermal fuse and NTC sensor are there to prevent any true overheating.

How long does an Electrolux washing machine heating element last?

Heating elements typically last 5 to 10 years depending on water hardness and usage. Hard water deposits build up on the element and cause it to overheat and burn out faster. Using a monthly drum cleaner helps extend element life.