E10
Frigidaire Washer
Severity: ModerateWhat Does This Error Mean?
E10 means your Frigidaire washer is not getting enough water to fill up. The cycle cannot start without sufficient water. This is usually a simple fix — start by checking your water supply.
Affected Models
- Frigidaire FFTW4120SW
- Frigidaire FFTW1001PW
- Frigidaire Gallery FGFW4065PW
- Frigidaire Classic Series
Common Causes
- Hot or cold water supply valves behind the washer are turned off
- Water inlet hoses are kinked, bent, or clogged with sediment
- Water pressure in the home is too low for the washer to fill properly
- Inlet valve filter screens are clogged with mineral deposits
- Water inlet valve has failed and is not opening to let water in
How to Fix It
-
Check that both hot and cold water taps behind the washer are fully open.
These valves are on the wall where the hoses connect. Turn them counterclockwise to open.
-
Inspect the water inlet hoses for any kinks or tight bends.
Straighten any kinked hoses. Make sure they aren't pinched behind the washer.
-
Turn off the water supply, disconnect the hoses, and check the filter screens.
Small mesh screens sit inside the hose connections at the back of the washer. Clean them with a brush.
-
Check your home's water pressure by running a nearby faucet.
The faucet should have strong, steady flow. Weak household pressure will prevent filling.
-
If everything looks fine and E10 continues, test the water inlet valve.
A faulty inlet valve needs replacing — call a technician or order the part online.
When to Call a Professional
If the water inlet valve has failed, a technician can replace it quickly. This repair is straightforward but involves disconnecting water lines.
Frequently Asked Questions
Why does my Frigidaire washer show E10 only sometimes?
Intermittent E10 errors often point to low water pressure during peak usage times. If neighbors are showering or watering lawns at the same time, pressure drops. Clogged filter screens can also cause inconsistent filling.
Can I fix E10 myself?
Yes — most E10 causes are DIY-friendly. Checking valves, straightening hoses, and cleaning filter screens are all easy tasks. Only the inlet valve replacement needs a bit more confidence.
How do I clean the inlet valve filter screens?
Turn off the water supply and disconnect the hoses from the back of the washer. The small mesh screens are visible inside the connection ports. Rinse them under running water and use a soft toothbrush to remove mineral buildup.