F1E2
Maytag Washer
Severity: CriticalWhat Does This Error Mean?
F1E2 means the motor control board in your Maytag washer has failed. This board tells the motor how and when to spin the drum. Without it working, the washer cannot complete any cycle.
Affected Models
- Maytag MVWB865GW
- Maytag MVWC465HW
- Maytag MVWB835DW
- Maytag Bravos XL
Common Causes
- Motor control board has burned out or failed
- Power surge that damaged the motor control electronics
- Overheating caused by a blocked ventilation area near the board
- Wiring harness connecting the board to the motor is loose or broken
- Repeated motor overloads that eventually burned out the board
How to Fix It
-
Stop the cycle immediately and press Cancel.
Running the washer with a motor board fault can damage the motor itself.
-
Unplug the washer for 5 minutes.
This resets the control electronics and may clear a temporary fault.
-
Plug the washer back in and run a short cycle.
If the error does not return, continue monitoring for recurrence.
-
Check that the washer is not overloaded.
Consistently heavy loads strain the motor and the control board over time.
-
If F1E2 keeps coming back, call a Maytag technician.
The motor control board will need to be tested and likely replaced.
When to Call a Professional
F1E2 is a hardware failure that requires a technician. The motor control board must be tested and replaced by someone with the right tools and parts.
Frequently Asked Questions
What is the motor control board?
It is the electronic board that directly drives the wash motor. Think of it as the translator between the main brain and the drum.
Can overloading a washer cause F1E2?
Yes — repeatedly running very heavy loads puts extra stress on the motor. Over time this can wear out the control board that manages it.
How much does it cost to replace a motor control board?
The part typically costs $80 to $180. With a technician's labor, the total repair is usually $200 to $350.