Maytag Washer Error Code F7E2 — What It Means & How to Fix It

What Does This Error Mean?

F7E2 means your Maytag washer has detected a fault in the motor speed sensing circuit — similar to F7E1 but flagging a different point in the speed control system. The washer cannot confirm the motor is running within its target speed range and stops the cycle. A load check and power reset are the first steps.

Affected Models

Maytag MVWB865GW
Maytag MVWC465HW
Maytag MVWB835DW
Maytag Bravos XL

Common Causes

Motor tachometer (speed sensor) has failed and is returning incorrect signals to the control board
Wiring harness connection to the motor speed sensor is loose or damaged
Motor is mechanically strained by worn bearings increasing resistance on the drum shaft
Overloaded drum preventing the motor from reaching target speed
Control board error in interpreting the motor speed feedback signal

How to Fix It

Check that the load is balanced and not overloaded.

F7E2 can appear when a heavy, unbalanced load prevents the motor from reaching target spin speed. Redistribute items and try again before investigating the motor.
Remove some items if the drum is packed full, then restart.

Reduce the load to about three-quarters full and run a short cycle to see if F7E2 clears.
Unplug the washer for 1 minute and restart.

A power reset clears transient motor speed faults. If the error disappears and the load was correctly sized, no further action is needed.
If F7E2 returns on normal loads, listen for unusual sounds during spin — grinding, humming, or scraping.

These sounds indicate worn motor bearings, which increase mechanical resistance and make it harder for the motor to reach target speed.
Have a technician test the speed sensor resistance and inspect the motor bearings.

The technician can confirm whether the speed sensor is within its rated resistance range or whether the motor bearings have worn to the point of replacement.

When to Call a Professional

If F7E2 persists on correctly loaded cycles after a power reset, the motor speed sensor or motor bearings need professional inspection. A grinding or humming noise during spin is a sign that motor bearings are worn and contributing to the fault.

Frequently Asked Questions

What is the difference between F7E1 and F7E2?

Both indicate a motor speed sensing fault, but they are detected at different points in the motor control circuit. Practically, the causes and fixes are nearly identical — load imbalance and a failing speed sensor are the most common causes of both.

Can worn drum bearings cause F7E2?

Yes. Worn bearings increase resistance on the drum shaft, making it harder for the motor to reach target speed. If you hear grinding or rumbling during spin, worn bearings are likely contributing to F7E2.

How do I know if it is the sensor or the motor?

A technician can test the sensor's resistance output to confirm whether it is within range. If the sensor tests good but F7E2 persists, the motor or bearings are the next suspect.