Tripping Circuit Breaker
Napoleon Electric Fireplace
Severity:Note: This issue may not appear as a code on your device's display. This page helps you troubleshoot the underlying problem.
What Does This Error Mean?
Napoleon electric fireplace tripping the breaker is caused by a circuit overloaded with too many devices, a faulty internal component drawing excess current, or a weak circuit breaker. Plug the fireplace into a dedicated circuit with nothing else on it.
How to Fix It
-
Move the fireplace to a dedicated circuit
-
Use a direct wall socket — no extension leads
-
Test on a different circuit
-
Check whether the breaker trips immediately or after a delay
-
Have an electrician assess the circuit
Frequently Asked Questions
Napoleon fireplace only trips the breaker on the high heat setting — cause?
On the 1500W high setting, the fireplace draws near the maximum current for a standard 10A breaker. If the circuit also supplies other loads or the breaker is aging, it may trip. Move to a dedicated socket and use the 750W low setting.
Napoleon fireplace trips the breaker after 20 minutes — is this an overload?
A time-delayed trip (after minutes of use) is a thermal trip — the breaker is overheating from sustained high current. This confirms the circuit is overloaded. Move the fireplace to a less-loaded circuit.
Is it safe to reset the breaker and keep using the Napoleon fireplace?
Reset once to confirm the trip was transient. If the breaker trips again on the same circuit, stop using the fireplace on that circuit and investigate the overload. Repeatedly resetting a tripping breaker can damage wiring.