Gimbal Error
Autel Robotics Drone
Severity: ModerateWhat Does This Error Mean?
Autel EVO gimbal error means the camera stabilisation system is not responding correctly. Remove the gimbal protector, power cycle the drone, and run a gimbal calibration from the Autel Sky app.
Affected Models
- Autel EVO Lite
- Autel EVO Lite+
- Autel EVO Nano+
Common Causes
- Gimbal clamp or protector left on during flight
- Gimbal knocked or dropped causing a mechanical jam
- Gimbal calibration data corrupted by firmware update
- Loose ribbon cable between the gimbal and aircraft body
- Gimbal motor overloaded from a prop wash or tight mounting
How to Fix It
-
Remove the gimbal protector/clamp before powering on.
The orange or red plastic gimbal guard must be removed before every flight. Leaving it on blocks gimbal movement and immediately triggers a gimbal error.
-
Power cycle the drone completely.
Power off, wait 10 seconds, and power back on. The gimbal runs a self-test at startup. Many transient errors clear with a fresh power cycle.
-
Run gimbal calibration in Autel Sky.
Go to Autel Sky → Settings → Gimbal Calibration. Place the drone on a flat surface and do not touch it during calibration. Calibration takes about 30 seconds.
-
Check the gimbal ribbon cable connection.
If you recently crashed, the ribbon cable between the gimbal and the aircraft body may have come loose. Gently reseat the connector — consult the Autel repair guide or contact support if unsure.
-
Contact Autel Robotics support if the error persists.
A gimbal motor or ribbon cable fault requires professional repair. Autel offers a repair program — visit autelrobotics.com/support.
Frequently Asked Questions
Is the Autel EVO Nano gimbal replaceable?
Yes. Autel sells replacement gimbal units for the EVO Nano and Lite. Swapping the gimbal is a fairly simple procedure — detailed in the Autel repair documentation.
Why does my gimbal tilt to one side after a crash?
A crash can bend the gimbal arm or snap a motor wire. If power cycling and calibration do not fix the tilt, the gimbal has physical damage and needs replacement.