E01, E02, E03, E05, E06, E19
Bosch Dishwasher
Severity: CriticalWhat it means
Each of these codes means the main control board has found a fault in one of the circuits it runs.
Bosch gives the same first step for all of them: switch the power off at the breaker for 30 seconds, then on again.
If the code comes back, the dishwasher needs a Bosch technician.
The list below shows which part each code points to.
Common Causes
- E01: the circuit that drives the heat pump, Bosch's name for the main wash pump with its built-in heater
- E02 and E03: a relay on the main control board
- E05: the circuit for the wash arm diverter, which sends water to the upper or the lower spray arm
- E06: the door sensor circuit
- E19: the circuit for the detergent dispenser solenoid, the small latch that pops the detergent lid open
How to Fix It
-
Switch the dishwasher off at the circuit breaker for 30 seconds.
If yours plugs into a socket under the sink, unplugging it works too.
-
Restore power and start a program.
A one-off glitch clears with the reset, and the dishwasher runs normally.
-
For E06, also check that the door closes fully.
Look for a rack, a utensil or a tray that stops the door from shutting completely.
-
If the same code comes back, stop and contact Bosch service.
Give them the exact code and the model number from the label on the edge of the door.
The code tells the technician which circuit to test.