E01 / E02

Bosch Dryer

Severity: Minor

What it means

Bosch lists E01 and E02 together: the lint filter is blocked and air cannot pass through it.
The filter can look clean and still be blocked.
Fabric softener leaves a thin film on the mesh that is hard to see.
Rinse the filter under running water, let it dry completely, and put it back.

Common Causes

  • Lint left on the filter from earlier loads
  • A film of fabric softener residue on the mesh, which you usually cannot see
  • The filter put back while still wet, so fresh lint sticks and clogs it quickly

How to Fix It

  1. Take out the lint filter and remove the lint from it.

    Your manual shows where the filter sits on your model.

  2. Rinse the filter under warm running water.

    Hold it up to the light afterwards.
    Water should run straight through the mesh.
    If it pools on top, the softener film is still there, so keep rinsing.

  3. Let the filter dry completely before you put it back.

    A damp mesh holds on to fresh lint and blocks again quickly.

  4. Make it a habit: empty the filter after every load, and rinse it now and then.

    Bosch recommends clearing it after each drying cycle.

  5. If E02 comes back with a clean, dry filter, unplug the dryer or switch it off at the breaker for 30 seconds.

    Bosch's US code list also gives E02 as a fault on the main control board relay.
    If the code survives the reset, call Bosch service.

Frequently Asked Questions

Why do I get E01 when I cleaned the filter yesterday?

Picking the lint off does not remove softener film.
Only rinsing does.
If you use softener or dryer sheets, rinse the filter every few weeks, not just when the code appears.